• Print
• Login

Set up the Equipment

<^< The LCD Display | Course Index | LCD Displays >^>

The diagram below shows you the E-blocks equipment you will need for this section:

Multiprogrammer Hardware settings:	Setting:
PICmicro Device	16F1937
Power supply	13.5V
SW1 (Fast/Slow)	N/A
SW2 (RC/XT)	XT
XTAL	19 660 800 Hz
PORTA	N/A
PORTB	LCD Board
PORTC	N/A
PORTD	N/A
PORTE	N/A
LVP Selection Jumper	I/O PORT
J12-14 (ICD2-USB)	USB
J29 (PSU-USB)	PSU

Note that in this experiment we will use the Crystal Oscillator and you will need to change the switch settings on your Multiprogrammer board, and in the Flowcode you can do this by selecting 'Build' from the main menu, then selecting 'Project Options...' and fianlly going to the 'Configure' tab where you will see a list of options (Build > Project Options... > Configure).

<^< The LCD Display | Course index | LCD Displays >^>